Kathrein CAS 09 Service Manual download pdf (Page 12)

935.2098/C/1205/4.8e

c) Mounting the support arm and the reflector

 Mount the support arm on the mast as shown in the

drawing

 In doing so, tighten the wing-nuts on the mast clamp

only slightly until the bracket holds securely for the

further mounting on the mast.

 Then lower the reflector into the pre-positioned

securing screws.

 Tighten the securing screws only slightly at first by

holding the short end of the hexagon spanner until the

screws are hand-tight.

 Now turn the hexagon spanner around. If you now

give the screws an extra one-quarter of a turn using

the long end of the spanner they are fully tightened. If

you should happen to have a torque wrench available,

tighten the screws to about 4-5 Nm.

First tighten slightly…

Only tighten sightly

…then effect 1/4 of a turn to

screw down

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Kathrein CAS 09 Service Manual Page 12