Kathrein EXR 2998 Service Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Q
Cascadable multi-switch for splitting 8 Sat levels and
terrestrial signals to multiple receivers
Q
Only one downlink per receiver needed (two for twin
receivers)
Q
Facility to select horizontal/vertical, low/high, Sat position A/
position B independently for each receiver using DiSEqC™
controls
Q
If not using DiSEqC™ controls, changing the horizontal/
vertical, low/high of Sat position A can be performed, also by
tone burst changing Sat position A/position B
Q
Integral amplifi er for low attenuation in Sat signal band
Q
Integral pre-emphasis to equalise cable attenuation
Q
Terrestrial signals also receivable with Sat receiver switched
off
Q
Terrestrial band: 5-862 MHz, passive
Q
High degree of insulation between outputs
Q
Can be remote fed via the horizontal low inputs.
All other inputs are voltage-free (enabling operation with
UAS 485)
Q
For indoor mounting
EXR 2908
Q
Multi-switch for 8 connections, with integral power supply unit
Q
Low power consumption based on high-effi ciency short-
circuit-proof switch-mode power supply unit
Q
Can be extended using EXR 2998
EXR 2998
Q
Multi-switch loop-through for system extension with eight
connections each
Q
Highly cascadable (up to 40 connections)
Sat-IF splitting system (8 x Sat-IF)
Multi-switch
EXR 2908
EXR 2998
20510019
20510020
Multi-switch
936.3280/B/0809/1.3e
Setting Effect
22 kHz ĺ High/Low All inputs position “A” can be selected
Tone Burst ĺ Pos. A/B All inputs position “A” and “B” can be selected
*) The terms for the settings in the receiver menus are specifi c to the respective model and manufacturer!
Settings for receivers without DiSEqC™
Setting Effect
DiSEqC™ “On” All inputs can be selected
22 kHz and tone burst to “Off” Changeover time is shortened
Settings for receivers with DiSEqC™
EXR 2908
20510019
EXR 2998
20510020
Page view 3
1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments